FacebookTwitterDiggStumbleuponGoogle BookmarksRedditTechnoratiLinkedin

Welcome

The Martin Fleischmann Memorial Project is a group dedicated to researching Low Energy Nuclear Reactions (often referred to as LENR) while sharing all procedures, data, and results openly online. We rely on comments from online contributors to aid us in developing our experiments and contemplating the results. We invite everyone to participate in our discussions, which take place in the comments of our experiment posts. These links can be seen along the right-hand side of this page. Please browse around and give us your feedback. We look forward to seeing you around Quantum Heat.

Join us and become part of the project. Become one of the active commenters, who question our work and suggest next steps.

Or, if you are an experimenter, talk to us about becoming an affiliated lab and doing your work in a Live Open Science manner.

Username:
Password:
Remember me

Get Involved

TOPIC: Three point measurement

#449 11 years 1 month ago
Three point measurement

QHtrayeux's Avatar
OFFLINE
Karma: 0
My suggestion is: to enclose three cells in three equally built boxes A,B,C with an exit pipe on each to measure the temperature. Boxes A and B have a calibration wire and the middle box C has a Celani wire. Input air for the tree units is from the same source/temperature and they should not be able to warm up the neighbour. If running in parallel then cell A and B should have the same measurements and any difference with cell
C is the excess heat?
The administrator has disabled public write access.

#450 11 years 1 month ago
Three point measurement

jdk's Avatar
OFFLINE
jdk
Karma: 0
It depends on the margin of "zero" measurement errors and the size of the effect we want to measure. At the beginning of the experiment, we are not sure exactly how much heat our LENR device will make. We don't yet know how to optimize the conditions. Will we see micro-watts or mega-watts? Or no effect? If we see milliwatts of reaction, how can we confidently say we have found it? Look at the error potentials in all of the measurement channels. Can unknown (to us)chemical effects be happening? How do we run the control? What if we only have a few milliwatts of heat? This is a really difficult experiment.


jdk
The administrator has disabled public write access.

#457 11 years 1 month ago
Three point measurement

jdk's Avatar
OFFLINE
jdk
Karma: 0
The three point technique might work if all three cells remain in a static condition. The Celani wire may be chemically active. It could be a catalytically active generator of atomic hydrogen. The atomic hydrogen is a much better conductor of heat than molecular hydrogen. Thus, more heat will be conducted to the outside of the box, while the interior cools. The outer temperature will increase, but there will be no actual generation of extra heat. The increased surface temperature will persist as long as the atomic hydrogen is being generated. (it quickly reacts with itself to reform hydrogen.) Atomic hydrogen is notoriously difficult to measure. It is highly magnetic while H2 is not, and this may provide a path to create a real time assay. Oxygen is also slightly magnetic and is frequently measured using magnetic techniques. The probability is "high" that H1 is being generated (~50%), in my opinion.


jkd
The administrator has disabled public write access.

#458 11 years 1 month ago
Three point measurement

bob's Avatar
OFFLINE
bob
Karma: 14
This is why the Celani V2 protocol is far better. It is calibrated and assessed with no gas - so no convection/conduction in gas in the debate.

B
The administrator has disabled public write access.

#1011 2 years 10 months ago
Three point measurement

lasting's Avatar
OFFLINE
Karma: 0
I completely resolved my question when I read this post, thanks to the author for the very detailed description. I wrote my review on the https://cvwritingservicesuk.com/cv-writers-org-uk-review/, you can go in and read. Thank you very much for your attention in your time.
The administrator has disabled public write access.
Powered by Kunena Forum