FacebookTwitterDiggStumbleuponGoogle BookmarksRedditTechnoratiLinkedin


The Martin Fleischmann Memorial Project is a group dedicated to researching Low Energy Nuclear Reactions (often referred to as LENR) while sharing all procedures, data, and results openly online. We rely on comments from online contributors to aid us in developing our experiments and contemplating the results. We invite everyone to participate in our discussions, which take place in the comments of our experiment posts. These links can be seen along the right-hand side of this page. Please browse around and give us your feedback. We look forward to seeing you around Quantum Heat.

Join us and become part of the project. Become one of the active commenters, who question our work and suggest next steps.

Or, if you are an experimenter, talk to us about becoming an affiliated lab and doing your work in a Live Open Science manner.

Remember me

Welcome to the New Fire Discussions

Tell us and our members who you are, what you like and why you became a member of this site.
We welcome all new members and hope to see you around a lot!

TOPIC: glow stick 3 thoughts

#896 5 years 3 months ago
glow stick 3 thoughts

jdk's Avatar
Karma: 0
The gs3 is a partial differential design.
A vexing problem solved is the changes in gas chemical composition and the resulting changes in thermal conductivity between the active and reference channels. By sharing the same container along the tube, the only gaseous conductivity differences would stem from diffusion effects. Imagine one end of the system generating gas phase chemical changes. I think these concentration differences would rapidly vanish as high temperature thermal diffusion drives both sides of the system to near equilibrium.
Are there any other differences between thermal conductivity in the active and reference channels? Obviously the active channel is filled with highly thermally conductive metal powder while the reference side is filled with low conductivity gaseous hydrogen related moieties. For purposes of simplifying the modeling the thermal system, let us assume the center of the reactor core is the origin of heat transport. Which half of of differential system is going to have the most thermal conductivity to the outside world? I will guess that the powdered metal side of the reactor will have the most thermal conductivity and hence the outside temperature will be highest on the metal filled side. This positive temperature increase will be caused by differences in the thermal conductivity pathways (one side is powdered/sintered metal verses the hydrogen/allotrope gaseous transfer medium). Without hard conductivity numbers for the various substances but working under intuition, I would assume the metal is a better conductor of heat than almost all gases. Therefore the outer surface temperature should naturally be higher in the "active" zone (without LENR) and the claims for excess heat should be very cautiously considered.

jdk 03jun2015 22:25 central daylight time
The administrator has disabled public write access.

#897 5 years 2 weeks ago
glow stick 3 thoughts

bob's Avatar
Karma: 14
Hi jdk

the GS4 calibration alleviated these fears.

In the end - only statistically significant elemental and/or isotopic shifts provide hard evidence where some sort of flow calorimetry is not used.
The administrator has disabled public write access.
Powered by Kunena Forum