FacebookTwitterDiggStumbleuponGoogle BookmarksRedditTechnoratiLinkedin

High Voltage Sparky Powder Cell

High Voltage SPARK CellDescription:

A first generation of nano powder cell activated by Dr. Stoyan Sargoytchev's (Sarg) sparker. This cell is very similar to the current working cell, containing nano nickel and hydrogen. We have removed the thermo well in the powder area and added a high voltage pass-through with a nickel electrode through the top.

Location: USA   USflag

Project leader: Ryan Hunt

Time span: July 2014 - Now

Current progress: Installed and Calibrating

 

LIVE DATA  Experiment Notes

Latest Video | Gallery | RSS feed of all comments

Design and building

am .

Design components and parts helping to build the cell

building components for sparky cell

The "T" and everything that ends up in the cell was soaked or washed with alcohol. When dry, wash with acetone.

The parts regarding only the inner cell, from top to bottom:

High voltage pass-through on CF flange, copper CF gasket, CF "T", copper CF gasket, two sizes of ceramic tubes cut to appropriate lengths, two sizes of ceramic felt "spacers", thoriated tungsten TIG welding electrode; 3/32". Ceramic felt disc. Ceramic potting compound Resbond 919.

Parts of the inner sparky cell

The assambly of the inside cell:

A cut length of smaller diameter ceramic tubes were put over the nickel electrode so they (both sizes) fit up inside the pass-through.

Sparky cell pass-through

The nickel electrode was attached to tungsten electrode.

The appropriate length of the tungsten electrode was determined to cutt off, then sharpened.

The appropriate length of larger diameter ceramic tube was determined to reach the first felt spacers with smaller holes.

The number of 1/8" thick felt spacers with larger holes were used to ensure the outer tube stays centred in the cell and glue in place with Resbond 919.

The number of larger diameter tube spacers and small hole felt spacers were used, and assemble. When complete, the ends of the smaller and larger ceramic tubes should align.

Sparky cell inner

Using the Resbond, the ends of the ceramic tubes were glued together, and to the tungsten.


The assambly of the inner cell:
The cell was scrubed from inside, rinsed and dried.

The ceramic felt disc was pushed to the bottom of the cell. The cleaned "T" was instaled to the cell via a copper CF gasket and the electrode assembly was carefully placed via a copper CF gasket into the cell.

The cell will have 2 RTDs and a thermocouple for calorimetry, a Nichrome heater for pre-activation and a copper electromagnetic coil.

The feed wires for these electrical devices will pass through 3 sealed 1/4" stainless tubes from the ambient environment to the vacuumed environment surrounding the inner cell.


Spark it up!

 

Detailed methodology in Evernote

Building - Stage 1, Stage 2

Preparing the inner cell

 

 

 

Add comment


Security code
Refresh