FacebookTwitterDiggStumbleuponGoogle BookmarksRedditTechnoratiLinkedin

Welcome

The Martin Fleischmann Memorial Project is a group dedicated to researching Low Energy Nuclear Reactions (often referred to as LENR) while sharing all procedures, data, and results openly online. We rely on comments from online contributors to aid us in developing our experiments and contemplating the results. We invite everyone to participate in our discussions, which take place in the comments of our experiment posts. These links can be seen along the right-hand side of this page. Please browse around and give us your feedback. We look forward to seeing you around Quantum Heat.

Join us and become part of the project. Become one of the active commenters, who question our work and suggest next steps.

Or, if you are an experimenter, talk to us about becoming an affiliated lab and doing your work in a Live Open Science manner.

Last week a software glitch during a firmware update caused the power supply to fry the Celani wire in the B cell.  Ironically, we had just finished the 9 day calibration run when it happened.  After much deliberating, we decided to install a 360 layer wire that we had around.  Now we are running the calibration again.  Our plan is to compare the first few cycles with the previous ones and see if they fall in line well, or not.  We would have done that today except Malachi was out ill. 

 

The picture below shows the wire burned out right near the end.  The wire got heated and over currented, so it can't just be unwrapped one turn and re-fastened to the terminal a little shorter.

'

Mathieu's pair of cells are also going through calibration, still.  We are in a hurry to get this run done with before ICCF.  Hope it works.

Add comment

Security code
Refresh

Here is your generous contributions so far towards our $500,000 target, thanks everyone! : $45,020   Please Donate
See the current state of our booked costs here